Complete withEverything you need for installation
Practical rotary mixer
Some adviceWater escaping from the shower head after turning off the shower tap is not a defect but a technical requirement!
A solar shower is not a closed system. If there is a demand for hot water, cold water enters the tank from below through the valve and pushes out the hot water that is already in the upper part of the tank.
The entire shower body is filled with water and acts as a solar heating system.
The pressure that builds up as a result of the heating can leak from the shower head.
Because of the strong solar radiation, the water in the shower can reach up to 60° C (140° F). In this case, it is advisable to open the mixer in an intermediate position, between cold and hot, and set the desired temperature.
Dismantling at the end of the seasonDuring the winter period, the shower must be COMPLETELY drained of water. In addition, the shower should be dismantled and stored in a dry place during the winter.
Not complying with this warning can cause frost damage to the product.
Frost damage is not covered by the warranty.
1) Close the shower and remove the garden hose.
2) To drain the shower, turn the mixer back to the HOT position (approx. 2 minutes) and open the drain plug.
3) Remove the fixing screws on the base and drain the remaining water from the lower part of the shower by tilting the shower (absolutely necessary!)
CleaningConsumer detergents should be used for cleaning. Do not use cleaning agents containing solvents, abrasive cleaning agents or hard sponges, brushes, etc.